What's New:
- Tandy 10 emulation.
- Stop quadratic slowdown as printer output grows.
- Hardware serial port access on linux and mac via -r /dev/tty/USB0 or such.
- Becker port support for CoCo; -bck host:port or Serial → Becker menu.
- 68000 debugger for Model 16/6000 was always single stepping.
- MC-10 PEEK(2) quick keyboard check working; helps many Jim Gerrie games.
- Correct Model 3 and 4 memory mapped printer port to be read-only.
- Control of delay before cassette auto-save via -csd or Cassette → Save menu.
- Cassette now starts if inserted while CLOAD or SYSTEM in progress.
- Show .wav files in cassette open dialog by default if supported.
- Less awkward breakpoint GUI with a single window and addr1:addr2 for ranges.
- Printing on LDOS no longer reboots; emulator ignored printer interrupt disable.
- Model 2 hard-drive TRSDOS booting again. Oddly, same bug as LDOS printing.
- Replaced patched TRSDOS with proper Japanese TRSDOS.
- Allow Model 2/12/16/6000 access to Orchestra 90. Theoretically possible.
- Real Time Clock for Xenix enabled by default and now controlled by -rtc16 -rtc16x.
- CoCo cassette relay sound effects.
- CoCo Program Pak autostart control via menu or turned off by -pakq file.ccc.
- Printer window auto scrolls to bottom again on output.
- DT-1 half intensity display mode implemented.
- Event stream (-event endpoint) allowing external programs to blink LEDs, etc.
- Minor .wav output correction as .wav files should be an even number of bytes.
- CoCo FDC timing adjusted to hit 300 RPM precisely.
- FreHD emulation supports DSK/DCT LDOS driver to mount read-only disk images.